Netgear EDA500 – ReadyNAS Expansion Chassis 5-Bay, Diskless 하드웨어 매뉴얼

Press this button to turn on the ReadyNAS. The LED indicates these states:

On. Powered on.

Blinking. Booting or shutting down.

Off. Powered off.

Power button and LED

An LED on the top of the front panel is associated with each drive bay. LEDs are in
numerical order from left to right. The disk LEDs indicate these states:

On. Power is on and the disk is operating normally.

Blinking. The disk was removed, failed, or is resynchronizing. See the display
screen for details.

Off. The drive bay is empty.

Disk LEDs (1, 2, 3, 4)

The disk activity LED indicate these states:

Blinking. A disk is being accessed.

Off. All disks are idle.

Disk activity LED

Two LED status indicators are built into each port, one off or green and one showing
three states: off, amber, or green. They indicate port speed and activity as follows:

Green, green. 1000 Mbps connection speed, no activity.

Green blinking, green. 1000 Mbps connection speed, activity.

Green, amber. 100 Mbps connection speed, no activity.

Green blinking, amber. 100 Mbps connection speed, activity.

Green on, off. 10 Mbps connection speed, no activity.

Green blinking, off. 10 Mbps connection speed, activity.

Off, off. No connection.

Rear panel Ethernet port
LEDs

Displays messages about the status of your storage system. Note that the status
display screen goes to sleep to prevent burn-in. To wake it, press the Power button
once. If the storage system reports an abnormal operation or error, the status display
screen stays on.

Status display screen

This section describes how to power on and shut down your system. If you must shut down the system, use
one of the preferred shutdown methods whenever possible.