Netgear AirCard Hub 사용자 가이드
Advanced Settings
Rev 1 Feb. 2012
45
Some routes are added by default by the AirCard Hub on initialization such as the
Ethernet subnet route for routing to a device on the Ethernet subnet. A PPP route is
also added upon obtaining a WAN PPP connection.
To add static routes:
1. Enter the required values in the fields for the route being added.
2. Click Add.
2. Click Add.
Note: You must increment the “Route no” by 1 for each route in the “Route no” field;
otherwise that route will be overwritten.
The Active Routing table at the bottom will then show the new route added.
To delete Static Routes, click the “Delete Entry” text (in blue).
To delete Static Routes, click the “Delete Entry” text (in blue).
RIP
RIP (Routing Information Protocol) is used for advertising routes to other routers.
Thus, all the routes in the AirCard Hub’s routing table are advertised to other nearby
routers. For example, the route for the AirCard Hub’s Ethernet subnet could be
advertised to a router on the PPP interface side, so that a router on this network will
know how to route to a device on the AirCard Hub’s Ethernet subnet. You will need to
add the routes appropriately in the Static Routes section on page 44.
Figure 26: RIP Settings
To configure RIP Settings:
1. Select Enable on the RIP Page.
2. Select RIP version.
3. Click Save.
2. Select RIP version.
3. Click Save.
Note: Some routers ignore RIP.