Netgear AirCard 598U (Sprint) 사용자 가이드
139 Section 14D, The Hardware Tab
Allow simultaneous connections
If this box is checked, Sprint SmartView will allow you to establish more than one connection at
a time (for example, you could be connected to both WiFi and Mobile Broadband concurrently).
a time (for example, you could be connected to both WiFi and Mobile Broadband concurrently).
If this box is NOT checked, Sprint SmartView will prompt you to disconnect before allowing you
to establish a second connection.
to establish a second connection.
Prompt before switching connections
When in automatic connection mode, the Sprint SmartView software can automatically switch
to a higher priority network if one becomes available. However, since the original connection is
shut down once the new connection is fully established, this has the potential to disrupt any
activity that was relying on the original connection.
to a higher priority network if one becomes available. However, since the original connection is
shut down once the new connection is fully established, this has the potential to disrupt any
activity that was relying on the original connection.
If this box is checked, Sprint SmartView will prompt you for permission to switch networks
before it actually does so.
before it actually does so.
The Profiles Button
Click this button to open the The Network Profiles window.
The Device List
The device list is a four-column table that appears at the top of the Hardware tab of the Settings
window. It is primarily used to select and configure connected devices.
window. It is primarily used to select and configure connected devices.
Devices Column
This column lists all of the network access devices installed on your computer, grouped by the
connection technologies they use. Each technology type heading is followed by the device
names of the specific devices of that type that are installed on your computer. The technology
types are:
connection technologies they use. Each technology type heading is followed by the device
names of the specific devices of that type that are installed on your computer. The technology
types are:
●
Mobile Devices
●
ISDN Devices
●
WiFi Devices
●
Analog Dial-up Devices (Modems)
●
Ethernet Devices
●
Other Devices
Selected Column
This column allows you to specify which devices should be used to connect. The choices for
this column are:
this column are:
Automatic: Sprint SmartView will automatically choose the best device for this technology type.
Note
The behavior of this interface is significantly different for devices listed under the
Other Devices
heading. See “Other Devices” on page 140 for more information.