Netgear DC112A (Zain) – Zain Smart Cradle 사용자 설명서

Check that the appropriate LEDs are on for your network devices. If your cradle and 
computer are connected to a separate Ethernet switch, make sure that the link LEDs are 
lit for the switch ports that are connected to your computer and cradle.

Wrong network configuration

Verify that the Ethernet card driver software and TCP/IP software are both installed and 
configured on your computer. 

Verify that the IP address for your cradle and your computer are correct and that the 
addresses are on the same subnet.

After verifying that the LAN path works correctly, test the path from your computer to a 

remote device.

From the Windows toolbar, click the Start button and select Run.

In the Windows Run window, type

<IP address>

where <IP address> is the IP address of a remote device such as your ISP DNS server.

If the path is functioning correctly, messages display that are similar to those shown in 

124.

If you do not receive replies, check the following:

Check that the IP address of your cradle listed in your computer as the default gateway. If 
DHCP assigns the IP configuration of your computers, this information is not visible in 
your computer Network Control Panel.

Check to see that the network address of your computer (the portion of the IP address 
specified by the subnet mask) is different from the network address of the remote device.