Netgear MBR1310 사용자 설명서

Connection Mode

Set the connection mode to Dial on Demand, Always On, or 
Manually Connect.

• With the default setting, Dial on Demand, a PPPoE connection 

automatically starts when there is outbound traffic to the 
Internet, and it is automatically terminated if the connection is 
idle based on the value in the Idle Timeout field.

• When the connection mode is set to Always On, the PPPoE 

connection automatically starts when the computer boots up, but 
the connection does not time out. The router keeps trying to 
bring up the connection if it is disconnected for some reason.

• If you select Manually Connect, you need to go to the Router 

Status screen and click the Connect button to connect to the 
Internet. The manual connection does not time out, and you 
have to click the Disconnect button on the Router Status screen 
to disconnect it.

Idle Timeout (In Minutes)

An idle Internet connection is terminated after this time period. If 
this value is zero (0), then the router keeps the connection alive by 
reconnecting immediately whenever the connection is lost.

Internet IP Address

If you log in to your service or your ISP did not provide you with a 
fixed IP address, the router finds an IP address for you 
automatically when you connect. Select Get Dynamically from 
ISP. 

If you have a fixed (static, permanent) IP address, your ISP has 
provided you with an IP address. Select Use Static IP Address 
and type in the IP address. 

Domain Name Server (DNS) 
Address

The DNS server is used to look up site addresses based on their 
names. 

• If your ISP gave you one or two DNS addresses, select Use 

These DNS Servers and type the primary and secondary 
addresses. 

• Otherwise, select Get Automatically From ISP. 

Note: If you get “Address not found” errors when you go to a 
website, it is likely that your DNS servers are not set up correctly. 
You should contact your ISP to get DNS server addresses.