Netgear WAG511 - Dual Band Wireless PC Card - 802.11a/b/g 사용자 설명서

3-2

You need to click the Initiate Ad Hoc button before you click Apply. Here is how you start an Ad 
Hoc network:

1. Fill in the Network Name (SSID).

2. Select the Computer-to-Computer (Ad Hoc) Network Type.

3. Click Initiate Ad Hoc.

4. Accept the default settings or make your changes and click OK.

5. Click Apply.

I can connect to the access point, but not 
the other computers on the network or to 
the Internet.

This could be a physical layer problem or a network 
configuration problem.
1. Check to make sure that the access point is physically 

connected to the Ethernet network.

2. Make sure that the IP addresses and the Windows 

networking parameters are all configured correctly. See 
the link to 

.

3. Restart the cable or DSL modem, router, access point, and 

computer.

Viewing the IP address.

To view the WAG511 Wireless PC Card IP address, click the 
WAG511 icon to open the Smart Wizard. Then check the IP 
address in the About page.

No IP address is assigned to the WAG511 
Wireless PC Card.

This may occur if you upgraded your WAG511 Wireless PC 
Card software and did not reboot your system. 
• Either restart your computer, or connect to a different access 

point.

• It does not usually help to shut down the Smart Wizard or 

disable/enable the card.

Note: Be sure all computers in your Ad Hoc network are configured with static IP 

addresses in the same subnet.