Netgear RBK50 – Orbi AC3000 Tri-band WiFi System 사용자 설명서

The following table describes the Orbi LED behavior.

Power

The Power LED is located above the Power On/Off button on the rear panel.

Solid green.Power is on.

Solid amber. The router or satellite is rebooting.

Blinking amber. Resetting to factory default settings.

Blinking red. The firmware is corrupted. 

Off. Power is not supplied.

Router ring

The ring LED is located on the top.

Solid white. The router is booting.

Off. The router finished booting and is working normally.

Blinking white. The router is resetting to factory settings.

Blinking amber. The router cannot connect to the Internet. See 

100.

Blinking blue and magenta. The Internet connection is blocked because 
you set up Internet traffic metering and reached the maximum allowed 
amount of Internet traffic.

Satellite ring 

The ring LED is located on the top.

Solid white. The satellite is booting.

Off. The satellite finished booting and is working normally.

Blue for 10 seconds. The connection between the router and the satellite 
is good.

Amber for 10 seconds. The connection between the router and the 

satellite is fair.

Blinking magenta. The satellite is not connected to the router.

Magenta for 10 seconds. The satellite cannot get an IP address from the 
router.

Router ring and satellite 
ring during sync

The ring LEDs are located on the top.

Blinking white. The Sync button was pressed.

Blue for 3 seconds.The sync between the router and satellite succeeded.

Magenta for 3 seconds. The router and satellite failed to sync. See 

99.