Netgear WGT624v1 - 108 Mbps Wireless Firewall Router 참조 매뉴얼

7-2

Troubleshooting

•

Check that you are using the 12 V DC 800mA power adapter supplied by NETGEAR for this 
product.

If the error persists, you have a hardware problem and should contact technical support.

When the router is turned on, the LEDs turns on for about 10 seconds and then turn off. If all the 
LEDs stay on, there is a fault within the router.

If all LEDs are still on one minute after power up:

•

Cycle the power to see if the router recovers.

•

Clear the router’s configuration to factory defaults. This will set the router’s IP address to 
192.168.0.1. This procedure is explained in 

.

If the error persists, you might have a hardware problem and should contact technical support.

If either the LAN LEDs or WAN LED do not light when the Ethernet connection is made, check 
the following:

•

Make sure that the Ethernet cable connections are secure at the router and at the hub or 
workstation.

•

Make sure that power is turned on to the connected hub or workstation.

•

Be sure you are using the correct cable:

When connecting the router’s WAN port to a cable or DSL modem, use the cable that was 
supplied with the cable or DSL modem. This cable could be a standard straight-through 
Ethernet cable or an Ethernet crossover cable.