Netgear R6220 - AC1200 Smart WiFi Router with External Antennas 사용자 설명서

Change the RIP settings.

Router Information Protocol (RIP) allows a router to exchange routing information with 
other routers. 

a. Select a RIP direction:

Both. The router broadcasts its routing table periodically and incorporates 
information that it receives.

Out Only. The router broadcasts its routing table periodically. 

In Only. The router incorporates the RIP information that it receives.

Disabled. This is the default setting. 

RIP-1. This format is universally supported. It is adequate for most networks, 
unless you are using an unusual network setup. 

RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the 
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses 
multicasting.

Click the Apply button.

Your changes are saved.

If you changed the LAN IP address of the router, you are disconnected when this change 
takes effect.

To reconnect, close your browser, relaunch it, and log in to the router

By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The 
router assigns IP, DNS server, and default gateway addresses to all computers connected to 
the LAN. The assigned default gateway address is the LAN address of the router. 

These addresses must be part of the same IP address subnet as the router’s LAN IP 
address. Using the default addressing scheme, define a range between 192.168.1.2 and 
192.168.1.254, although you can save part of the range for devices with fixed addresses.



Launch a web browser from a computer or wireless device that is connected to the 

network.

Type http://www.routerlogin.net or http://www.routerlogin.com.

A login screen displays.

Enter the router user name and password.

The user name is admin. The default password is password. The user name and 
password are case-sensitive.

The BASIC Home screen displays.