Netgear WNR3500Lv2 - N300 Wireless Gigabit Router 설치 가이드
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
modem to power.
Package Contents:
N300 Wireless Gigabit Router
WNR3500Lv2
Installation Guide
Power adapter
Ethernet cable
Step 1:
Unplug the power
to turn off your modem.
to turn off your modem.
Step 2:
Connect one end of the yellow
Ethernet cable to your modem, and
Ethernet cable to your modem, and
the other end to the Internet port on
your router.
your router.
Plug in, then turn on your modem.
Step 3:
Step 6:
Step 4:
Connect the power adapter to
the router, then plug it into an
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
the Power On/Off button is in the ON position
(pushed in).
outlet. Wait until the wireless LED
turns solid blue.
turns solid blue.
Step 5:
Connect your computer
to the router.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
located on the bottom label.
Open a browser.
If the Web page does not display,
close and re-open the browser
close and re-open the browser
and enter
http://routerlogin.net
in
the address bar, or check the
“Troubleshooting” section on
the back of this installation guide.
Laptop or Desktop
Computer
N E T G E A R
N300 Wireless Router
N300 Wireless Router
(not included)
Power On/Off
Modem
DSL
or cable
Internet
Power On/Off