Netgear WNR3500Lv1 - N300 Wireless Gigabit Router 설치 가이드

Manually Installing Your Router

18

 

When configuring your wireless router manually, you must log in to your N300 Wireless router to 
set it up initially and to make any changes to your wireless router’s settings later.

Type http://www.routerlogin.net in the address field of your browser, and then click Enter.

The factory default state is reset when you use the Restore Factory Settings button. 
See 

 for 

more information.

You can enter either of these addresses to connect to your wireless router:

http://www.routerlogin.net or http://www.routerlogin.com.

WPS. The WPS light will blink if you are in the process of using WPS to 
add a wireless client or there is a WPS error. See 

. The 

WPS light will be lit if WEP, WPA-PSK or WPA2-PSK security is set.

Power. The power light should turn solid green. If it does not, see 

.

Wireless. The wireless light should be lit after turning on the Product 

Family.

Internet. The Internet port light should be lit. If it is not, make sure the 
Ethernet cable is securely attached to the N300 Wireless router Internet 
port and the modem, and that the modem is powered on.

LAN. A LAN light (1-4) should be lit for each connected computer on 
your network. Green indicates that your computer is communicating at 
1000 Mbps; amber indicates communication at 10/100 Mbps. If a LAN 
light is not lit for each connected Ethernet cable, make sure that the 
Ethernet cable from the computer to the router is securely attached at 
both ends, and that the computer is turned on.