Netgear WNR2020v2 - 5PT N300 Wireless Router 사용자 설명서
Hardware Setup
7
N150 and N300 Wireless Routers
Hardware Features
Before you cable your router, take a moment to become familiar with the product label and
the front and back panels. Pay particular attention to the LEDs on the front panel.
the front and back panels. Pay particular attention to the LEDs on the front panel.
Front Panel LEDs
The router front panel has the following status LEDs.
Table 1. Front panel LED descriptions
LED
Description
Power
•
Solid green. The power is on, and the router is ready.
•
Blinking green. A firmware update is in progress.
•
Off. Power is not supplied to the router.
Internet
•
Solid green. An IP address was received; the router is ready to transmit data.
•
Off. No Ethernet cable is connected between the router and the modem.
WiFi
•
Solid green. The wireless radio is operating.
•
Off. The wireless radio is off.
Ethernet ports 1–4
•
Solid green. The Ethernet port has detected a 100 Mbps link with an attached
device.
device.
•
Off. The Ethernet port has not detected a link with an attached device.
Back Panel
The back panel has the following ports, button, and connector.
Table 2. Back panel port, button, and connector descriptions
Port or Connector
Description
Ethernet ports
Four local area networks (LAN) Ethernet ports for connecting the router to
your local computers.
your local computers.
Internet port
Ethernet port for connecting the router to a cable broadband modem or DSL
broadband modem. The Internet port is also referred to as the WAN port.
broadband modem. The Internet port is also referred to as the WAN port.
AC power connector
AC power connector to connect the power adapter to the router.
WPS/Reset button
This button is a WPS and Reset button:
•
WPS button to connect computer or WiFi devices to the router’s network.
For more information, see
For more information, see
•
Reset button to return the router to its factory settings.
For more information, see
For more information, see