Netgear WNR2000v2 - N300 Wireless Router 사용자 설명서

Troubleshooting

7-12

If your wireless network appears, but the signal strength is weak, check these conditions:

•

Is your router too far from your adapter, or too close? Place the computer that has the adapter 
near the router, but at least 6 feet away, and see whether the signal strength improves.

•

Is your wireless signal obstructed by objects between the router and your adapter? See 

.

This section explains how to restore the factory default configuration settings that reset the 
router’s user name to admin, the password to password, and the IP address to 192.168.1.1.

You can erase the current configuration and restore factory defaults in two ways:

•

.

•

Use the restore factory settings button on the rear panel of the router. Use this method for cases 
when the administration password or IP address is not known.

To use the restore settings button:

1. Locate the restore factory settings button on the rear panel of the router.

2. Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings 

button for about 5 seconds, until the Power light begins to blink.

3. Release the restore factory settings button, and wait for the router to restart, and for the Power 

light to stop blinking and become solid green.

The factory default settings will be restored so that you can access the router from your Web 
browser using the factory defaults.

If the wireless router fails to restart, or the Power light continues to blink or turns solid amber, the 
unit might be defective. If the error persists, you might have a hardware problem and should 
contact Technical Support at 

Warning: These procedures erase all current configuration settings.