Netgear WNR2000v2 - N300 Wireless Router 사용자 설명서

Customizing Your Network Settings

4-15

Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless 
connection to the base station.

To configure a WNR2000v2 router as a repeater unit:

1. Log in to the router that will be the repeater. Check the Wireless Settings screen, and verify 

that the wireless settings match the base unit exactly. The wireless security option must be set 
to WEP or None.

2. In the Wireless Repeating Function screen (depending on the frequency you want to use), 

select the Enable Wireless Repeating Function check box and the Wireless Repeater radio 
button.

3. Fill in the Repeater IP Address field. This IP address must be in the same subnet as the base 

station, but different from the LAN IP of the base station

4. Click Apply to save your changes.

5. Verify connectivity across the LANs. 

A computer on any wireless or wired LAN segment of the wireless router should be able to 
connect to the Internet or share files and printers with any other wireless or wired computer or 
server connected to the other AP.

The WNR2000v2 router can be used with a wireless access point (AP) to build large bridged 
wireless networks. Wireless repeating is a type of Wireless Distribution System (WDS).

Note: If you are using the WNR2000v2 base station with a non-NETGEAR wireless 

router as the repeater, you might need to change additional configuration settings. 
In particular, you should disable the DHCP server function on the wireless 
repeater AP.

Warning: If you use the wireless repeating function, your options for wireless security 

are limited to None or WEP. For more information about wireless security, see