Netgear WNR1000v2 - N150 Wireless Router 사용자 설명서

Troubleshooting

7-5

2. Check that PIN verification has succeeded for the WPS-enabled device you are connecting to 

the router.

3. Make sure you have not pushed the push-button after disabling the WPS function (you logged 

into the router and disabled this previously).

4. Check that the router is not in the temporary AP setup locked state (if you are using the 

wireless repeater function).

For more information on WPS, see 

If you are unable to log in to the wireless router, check the following:

•

If you are using an Ethernet-connected computer, check the Ethernet connection between the 
computer and the router as described in the NETGEAR Wireless Router Setup Manual.

•

Make sure you are using the correct login information. The factory default login name is 
admin and the password is password. Make sure that the Caps Lock is off when entering this 
information.

•

Make sure your computer’s IP address is on the same subnet as the router. If your are using the 
recommended addressing scheme, your computer’s address should be in the range of 
192.168.1.2 to 192.168.1.254. Refer to your computer’s documentation or see 

 for help with configuring your computer.

•

If your router’s IP address has been changed and you don’t know the current IP address, reset 
the router’s configuration to the factory defaults. This procedure will reset the router’s IP 
address to 192.168.1.1 (see 

).

•

Make sure your browser has Java, JavaScript, or ActiveX enabled. If you are using Internet 
Explorer, click Refresh to be sure the Java applet is loaded. Try closing the browser and 
reopening it again.

Note: If your computer cannot reach a DHCP server, some operating systems will 

assign an IP address in the range 169.254.x.x. If your IP address is in this 
range, verify that you have a good connection from the computer to the router, 
then restart (reboot) your computer.