Netgear WNR2200 - N300 Wireless Router 설치 가이드
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
modem to power.
Package Contents:
N300 Wireless Router
WNR2200
Installation Guide
Power adapter
Ethernet cable
Step 1:
Unplug the power
to turn off your modem.
to turn off your modem.
Step 2:
Connect one end of the yellow
Ethernet cable ( ) to your modem,
and the other end to the Internet port
on your router.
and the other end to the Internet port
on your router.
Plug in, then turn on your modem.
Step 3:
Step 6:
Step 4:
Connect the power adapter to the
router, then plug it into an outlet.
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
Wait until the wireless LED turns
solid green.
solid green.
Step 5:
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
located on the bottom label.
Open a browser.
If the Web page does not display,
close and re-open the browser
and enter
close and re-open the browser
and enter
http://routerlogin.net
in
the address bar, or check the
“Troubleshooting” section on
the back of this installation guide.
Laptop or Desktop
Computer
N300 Wireless Router
Modem
or Cable
Internet
DSL
N300 Wireless Router
(not included)
Connect the router
to your computer ( ).
to your computer ( ).
Power On/Off