Netgear EX7000 – Nighthawk AC1900 WiFi Range Extender 사용자 설명서
Get Started
14
AC1900 WiFi Range Extender
Install the Extender to Boost Your WiFi Range
The most common way to use the extender is to boost the range of your existing WiFi
network. You can also use the extender as a WiFi access point and create a new WiFi
hotspot by using a wired Ethernet connection. For information about access point installation,
see
network. You can also use the extender as a WiFi access point and create a new WiFi
hotspot by using a wired Ethernet connection. For information about access point installation,
see
Set Up the Extender Hardware
To set up the extender hardware:
1.
Attach the stand or the rubber feet.
10.
2.
Attach the antennas.
10.
3.
Turn on your extender.
Place the extender close to your WiFi router. Plug the extender into an electrical outlet.
Press the Power button if necessary.
Press the Power button if necessary.
The NETGEAR LED lights white and the Link Rate LEDs and the Device to Extender LED
light amber and then turn off.
light amber and then turn off.
Use WPS to Connect the Extender to Your WiFi Router
You can use WiFi Protected Setup (WPS) to connect the extender to your WiFi router without
typing your existing router’s WiFi network name (SSID) or WiFi password. If you do not want
to use WPS, see
typing your existing router’s WiFi network name (SSID) or WiFi password. If you do not want
to use WPS, see
15.
To use WPS to connect the extender to your WiFi router:
1.
Make sure that the extender is powered on.
2.
Press the WPS button on the extender.
Both Link Rate LEDs
and the Device to Extender LED
blink green for two
minutes.
3.
Within two minutes, press the WPS button on your WiFi router.
4.
Add a WiFi band.
If your WiFi router supports the 5 GHz band (not all routers do), and you want to extend
that band, repeat and check that the 5 GHz Link Rate LED lights green to confirm the
connection.
that band, repeat and check that the 5 GHz Link Rate LED lights green to confirm the
connection.