Netgear PR2000 - Trek N300 Travel Router and Range Extender 사용자 설명서

You can set up your Trek with the NETGEAR genie automatically, or you can use the genie 
menus and screens to set up your Trek manually. However, before you start the setup 
process, you need to have your ISP information on hand and make sure the laptops, 
computers, and other devices in the network have the required settings.

If you set up your computer to use a static IP address, you must change the settings so that it 
uses Dynamic Host Configuration Protocol (DHCP). 

For DSL broadband service, when your Internet service starts, your Internet service provider 
(ISP) typically gives you all of the information needed to connect to the Internet. You might 
need this information to set up the Trek to use your Internet service. If you cannot locate this 
information, ask your ISP to provide it. When your Internet connection is working, you no 
longer need to launch the ISP login program on your computer to access the Internet. When 
you start an Internet application, your Trek automatically logs you in. You might need the 
following information to set up your Trek:

The ISP configuration information for your DSL account

ISP login name and password

Fixed or static IP address settings (special deployment by ISP)

Make sure that the wireless device or computer that you are using supports WPA or WPA2 
wireless security, which is the wireless security supported by the Trek. For information about 
the Trek’s preconfigured security settings, see 

Different types of logins have different purposes. It is important that you understand the 
difference so that you know which login to use when.

Types of logins:

Trek login. The login that your ISP provided logs you in to the Trek interface from 
NETGEAR genie. See 

about this login.

ISP login. This logs you in to your Internet service. Your service provider gave you this 
login information in a letter or some other way. If you cannot find this login information, 
contact your service provider.