Netgear WNDA4100 – N900 Wireless Dual Band USB Adapter 설치 가이드

Installation Guide

Estimated completion time: 10 minutes. 

Insert the Resource CD in your computer’s CD drive. If the CD main screen 

does not display, browse the files on the CD and double-click Autorun.exe.

Click Setup.

The Software Update Check screen displays. 

If you are connected to the Internet, click Check for Updates. If not, then click 

Install from CD.

Click I agree to accept the license agreement and then click Next. 

A message displays asking you to 
wait while software is installed. This 
might take a few minutes. Then you 
are prompted to insert your adapter.

Either insert the adapter into a USB 

port on your computer, or use the 

USB cable and adapter cradle 

provided to connect the adapter.

The USB cable and adapter cradle 
can extend the range of your adapter 
and improve wireless reception. 
Insert the adapter in the cradle and 
attach the USB cable to the 
computer.

Note: For best results, put the 
wireless adapter at least 4 feet 
(1 meter) away from your router. 

Click Next. 

NETGEAR Genie displays a list of wireless networks in your area.

You can join a wireless network from this NETGEAR Genie screen, or you can use 
Wi-Fi Protected Setup (WPS) if your wireless network supports it.

NETGEAR Genie: Click your wireless network to select it from the list, and then 

click Connect. If the network is secure, enter its password or network key. 

WPS: Press and hold the WPS button on the side of the adapter for 2 seconds.

Within 2 minutes, press the WPS button on your wireless router or gateway.