KitchenAid 30" Convertible Hood with 400 CFM Rating 설치 가이드

 

■

4 - 8 x 40 mm wall anchors

 

■

Recirculating kit

 

■

Charcoal filters for non-vented (recirculating) installations. 

See the “Assistance or Service” section to order 

replacement filters.

 

■

3

1

/

4

" x 10" (8.3 x 25.4 cm) or 6" (15.2 cm) or larger 

round metal venting

 

■

6" (15.2 cm) or larger round damper, if using 

6" (15.2 cm) or larger round vent system

 

■

3

1

/

4

" x 10" (8.3 x 25.4 cm) to 6" (15.2 cm) or larger 

diameter transition piece if using 6" (15.2 cm) or 

larger diameter round vent system.

 

■

Two 2" (5.1 cm) wide filler strips. Length and 

thickness determined by recess dimensions.

 

■

Four flat-head wood screws or machine screws 

with washers and nuts (to attach filler strips).

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

 

■

It is the installer’s responsibility to comply with installation 

clearances specified on the model/serial/rating plate. 

The model/serial/rating plate is located inside the range 

hood on the left wall.

 

■

Range hood location should be away from strong draft 

areas, such as windows, doors and strong heating vents.

 

■

Cabinet opening dimensions that are shown must be used. 

Given dimensions provide minimum clearance. Consult the 

cooktop/range manufacturer installation instructions before 

making any cutouts.

 

■

Grounded electrical outlet is required. See “Electrical 

Requirements” section.

 

■

This range hood is recommended for use with cooktops 

with a maximum total rating of 65,000 BTUs or less.

 

■

The hood is factory-set for vented installations.  

For non-vented (recirculating) installations, the 

Recirculation Kit is included. See the “Assistance 

or Service” section to order Replacement Charcoal 

Filters Part Number W10272068.

 

■

All openings in ceiling and wall where range hood 

will be installed must be sealed.

The installation of this range hood must conform to the 

Manufactured Home Construction Safety Standards, Title 

24 CFR, Part 328 (formerly the Federal Standard for Mobile 

Home Construction and Safety, title 24, HUD, Part 280) 

or when such standard is not applicable, the standard for 

Manufactured Home Installation 1982 (Manufactured Home 

Sites, Communities and Setups) ANSI A225.1/NFPA 501A, 

or latest edition, or with local codes.