KitchenAid 29.5 cu. ft 48-Inch Width Built-In Side by Side Refrigerator with PrintShield™ Finish 설치 가이드

Adjust Doors

Use the following steps to adjust the door height, up or down, 
after the doors have been leveled.

1. Open the freezer or refrigerator door. Locate the bottom hinge 

and remove the door stop screw.

Stainless Models 

Remove the door stop screw from the bottom side of the 
hinge with a 

³⁄₈" open end wrench.

Remove the 2 door stop screws: one from the bottom side 
using a 

³⁄₈" open end wrench and one from the top side using 

a 

⁵⁄₃₂" hex key.

2. Remove the locking plate as shown.

3. Turn the bushing located underneath the bottom of the hinge 

using a 

¹⁄₂" open end wrench. Turning the bushing to the left 

will lower the door. Turning the bushing right will raise the 
door. 

4. After adjusting, check the doors to make sure they are even 

at the top and bottom. If the doors are not even, continue to 
turn the bushing to adjust the door height. 

5. Replace the locking plate. 

6. Turn the bushing slightly to align the hinge and locking plate 

screw holes. 

7. Replace the door stop screw or screws and tighten.

IMPORTANT: Do not place the door stop screw in the 130° 
position on Overlay Series models unless the custom panels 
have been routed on the hinge side. See “Overlay Series Door 
Panel and Cabinetry Clearance.”

8. Recheck to make sure the doors are aligned and even.

1. Check that the refrigerator door can open freely. If the door 

opens too wide, remove the door stop screw or screws 
(depending on your model) from the bottom hinge. See “Door 
Height Adjustment” earlier in this section. 

2. Hold the door open to a position that is less than 90°.

3. Replace the door stop screw or screws in the bottom hinge 

and tighten.

1. Loosen, but do not remove, the four Torx

®†

 27 flat-head 

mounting screws. Remove and discard the two 

¹⁄₄" hex-head 

mounting screws.

2. Adjust the top hinge of either door to align it with the other 

door or the refrigerator trim.

3. Tighten the four Torx

®†

 27 flat-head mounting screws to a 

torque of approximately 100 inch-pounds (11.3 Nm).

A

B

C

A

B

¹⁄₄

A

B

C

†®TORX is a registered trademark of Acument Intellectual Properties, LLC

A

B