Xerox Document Workstation with PlotWorks Support & Software 사용자 가이드
PlotWorks User Guide • The Job Editor • 4-59
To create a label:
1.
Click on the Labels tab of the Detail Property Sheet.
2.
To offset the label from its starting point, the lower-left edge of the medium,
enter the desired offset amount in the X Pos and Y Pos fields.
enter the desired offset amount in the X Pos and Y Pos fields.
•
X Pos: X’ refers to the horizontal axis. Entering a positive number shifts
the X position to the right while a negative one shifts the X position to
the left.
the X position to the right while a negative one shifts the X position to
the left.
•
‘Y Pos: Y’ refers to the vertical axis. A positive number here shifts the
Y position up, a negative number shifts it down
Y position up, a negative number shifts it down
‘Entering a number larger than the actual medium size causes the label to snap to
the edge of the medium. This is an easy way to offset the label to the opposite side
of the medium. See example below.
the edge of the medium. This is an easy way to offset the label to the opposite side
of the medium. See example below.
Fig 4.33
Label lo-
cation
Label
Large X value
Label
Large Y value
Label
Large X &Y value
3.
Label rotation is applied so that the label is never cut off. Select the desired
degree of rotation relative to the lower-left corner of the label by clicking on
one of the Label Rotation radio buttons. Choices are: 0, 90, 180, and 270.
degree of rotation relative to the lower-left corner of the label by clicking on
one of the Label Rotation radio buttons. Choices are: 0, 90, 180, and 270.
Fig 4.34
Label rota-
tion
4.
Enter content for the label by either entering text in the Labels text box or use
the Label macros.
the Label macros.
•
Label macros: These are predefined macros that are used to enter
commonly used information for labels. These macros can be combined
commonly used information for labels. These macros can be combined