Xerox Document Workstation with PlotWorks Support & Software 사용자 가이드
PlotWorks User Guide • The Scanner Interface • Chapter 9-13
the XES MAX 200 or 8180, you cannot specify a width larger than the
actual document width.)
actual document width.)
•
Original height: The height of the original document in current units of
measure. When you select a standard size in the Size field, this field
automatically displays the correct height. If you select USER in the Size
field, you must enter a correct height value.
measure. When you select a standard size in the Size field, this field
automatically displays the correct height. If you select USER in the Size
field, you must enter a correct height value.
•
Document offsets: You can offset your scanned image from the edge of the
page. You can also set a negative* ‘Y’ or ‘X’ offset value to remove large
borders from your image. (*Only with KIP scanners)
page. You can also set a negative* ‘Y’ or ‘X’ offset value to remove large
borders from your image. (*Only with KIP scanners)
•
X offset: Enter an X offset distance (inches or mm) in this box. The X
axis is always the lead/trail edge of the image. The X offset limit is “X +
document width” not to exceed 36 inches.
axis is always the lead/trail edge of the image. The X offset limit is “X +
document width” not to exceed 36 inches.
•
Y offset: Enter a Y offset distance (inches or mm) in this box. The Y axis
is always the height of the image. The Y offset can be from 0 inches to
10 inches.
is always the height of the image. The Y offset can be from 0 inches to
10 inches.
Portrait
Landscape
Height (Y)
Width (X)
Width (X)
Height (Y)
•
Original Setup group box:
•
Bottom Edge: When the Scanner Interface is opened through the Job
Editor, users can use the Bottom Edge pull-down list to set the bottom
edge for the page being scanned. Users can select from: Bottom, Left,
Right, or Top.
Editor, users can use the Bottom Edge pull-down list to set the bottom
edge for the page being scanned. Users can select from: Bottom, Left,
Right, or Top.
•
Scanner Setup Parameters:
•
SCSI capability: (7356 Scanner only) When the Scanner is set to Auto
Scan, this field displays diagnostic information. If you are experiencing
scanning problems, Technical Support might ask you for the values in
this field to help them resolve the problem. In general, you can ignore
this field.
Scan, this field displays diagnostic information. If you are experiencing
scanning problems, Technical Support might ask you for the values in
this field to help them resolve the problem. In general, you can ignore
this field.