Xerox Phaser EX7750 설치 가이드
7
7-9
System software
After you power on, the EX7750 organizes the software on the system and then
reboots once (twice, if the monitor/keyboard/mouse option is enabled). Several
messages display indicating that the backup software is being installed. This segment
takes approximately 10 minutes. Wait for the system to boot completely and the Idle
screen to appear on the Control Panel.
reboots once (twice, if the monitor/keyboard/mouse option is enabled). Several
messages display indicating that the backup software is being installed. This segment
takes approximately 10 minutes. Wait for the system to boot completely and the Idle
screen to appear on the Control Panel.
11.
At the message “Please insert CD 3”, insert CD 3, and then close the drive drawer.
CD 3 installs automatically. Installation takes approximately one minute.
12.
At the message “Remove CD and recycle power”, remove CD 3. Then, using the power
switch on the back panel, power off the system, wait 10 seconds, and then power the
system back on.
switch on the back panel, power off the system, wait 10 seconds, and then power the
system back on.
After you power on, the EX7750 applies the content installed from CD 3 and then
reboots once more. Wait for the system to boot completely and the Idle screen to
appear on the Control Panel. This segment takes approximately six minutes.
reboots once more. Wait for the system to boot completely and the Idle screen to
appear on the Control Panel. This segment takes approximately six minutes.
13.
Reconnect any USB devices or dongles that you may have removed earlier.
14.
Configure Setup using the Configuration page you printed earlier.
15.
Reinstall fonts, user software, or custom simulations that may have been deleted
when you restored system software.
when you restored system software.