Xerox DocuColor 12 Printer with Fiery EX12 문서
9
Job Management Guide
Part Number: 45027236
N
OTE
:
When you specify a bleed, you move the trim marks into the page by the bleed value
on both the top and the bottom of the page, and on both sides of the page. Therefore, you
reduce the size of your finished page by twice the bleed amount. If your document uses
bleeds, design your image to be slightly larger than the size of the final, trimmed page and
select a larger paper size to accommodate trimming.
reduce the size of your finished page by twice the bleed amount. If your document uses
bleeds, design your image to be slightly larger than the size of the final, trimmed page and
select a larger paper size to accommodate trimming.
Scale settings
You can use Scale settings to enlarge or shrink the page by a specified amount.
Scale Mode
You can choose a scaling option from the Scale Mode menu:
Scale to Fit
—Scales page(s) to best fill the slot without printing past its edge. Scale to fit is
the default mode.
Printer’s Marks
This section is in addition to the “Printer’s Marks” section, immediately before the
“Properties” section in Chapter 6 of the Job Management Guide.
“Properties” section in Chapter 6 of the Job Management Guide.
Offset
—The Horizontal Offset and Vertical Offset fields determine the gap between the
printer’s marks and the trim lines on the page. This allows you to move the printer’s marks
away from the final trimmed area of the page. A positive offset moves the printer’s marks
out from the center of the page, and a negative offset moves the printer’s marks closer to the
center of the page.
away from the final trimmed area of the page. A positive offset moves the printer’s marks
out from the center of the page, and a negative offset moves the printer’s marks closer to the
center of the page.
10 point horizontal offset
10 point vertical offset