Xerox DigiPath Professional Production Software Support & Software 관리자 가이드
A
BOUT
D
IGI
P
ATH
X
EROX
D
IGI
P
ATH
P
RODUCTION
S
OFTWARE
1-4
S
YSTEM
A
DMINISTRATOR
G
UIDE
Powering up the hardware and starting DigiPath
1
This section contains instructions for powering up the DigiPath
workstation platform and hardware options.
workstation platform and hardware options.
It is very important you power up the hardware components in
the order presented below.
the order presented below.
1. If there is a scanner attached to the DigiPath workstation,
power up the scanner.
2. If there is a Windows printer attached to the DigiPath
workstation, power up the printer.
3. If there is a Magneto-Optical Drive (MOD) attached to the
DigiPath workstation, power up the MOD.
NOTE: If there is an optical disk in the MOD drive when the
drive is powered up, the startup time for the MOD is shorter.
drive is powered up, the startup time for the MOD is shorter.
4. If there is a RAID attached to the DigiPath workstation, power
up the RAID.
NOTE: Do not power off the RAID unless you are moving the
RAID to another workstation.
RAID to another workstation.
5. If there is an external tape drive attached to the DigiPath
workstation, power up the tape drive.
6. Power up the monitor.
7. Power up the workstation processor (CPU).
8. Log in to the network.
NOTE: It is recommended that you wait 2 - 5 minutes after
logging in to the network before logging into the DigiPath
applications.
logging in to the network before logging into the DigiPath
applications.
9. To open the DigiPath applications, select [Start: Programs:
Xerox DigiPath Production Software: <select the appropriate
DigiPath application>] from the Windows desktop.
DigiPath application>] from the Windows desktop.
NOTE: All DigiPath applications are found in the DigiPath
program group.
program group.
A
E
E
E
E