Zanussi ZCG63330BA 사용자 설명서

If the burner accidentally goes out,

turn the knob to the off position and

try to light the burner again after

minimum 1 minute.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

A) Burner cap

B) Burner crown

C) Ignition candle

D) Thermocouple

E) Hob

F) Slots

G) Burner body

H) Location peg

I) Hole

1. Put carefully the burner crown on the burner

body. Let the crown fall freely onto the

body. Do not use force. 

Make sure that the hole in the crown is

above the ignition candle.

Make sure that the location pegs are in the

slots in the burner body.

Make sure that you can move the crown a

small distance from side to side.

2. Put the burner cap centrally on top of the

crown (enamel side up). 

Make sure that the cap is correctly installed

and you can move the cap from side to side

and front to back.

3. Try to light the burner.

If the burner does not ignite, adjust the crown

and cap again.

To put the flame out, turn the knob to the off
position  .

Always turn the flame down or

switch it off before you remove the

pans from the burner.

Lid has safety device, which cuts off the gas

supply for the hob. It works only when the lid is

closed.

Always use the knob for the hob to

switch off a burner. Do not use the

lid as a cut-off device.

Refer to Safety chapters.

Do not put the same pan on two

burners.

Do not put unstable or damaged

pots on the burner to prevent from

spill and injury.

Make sure that pot handles are not

above the front edge of the cooktop.