Timberk SWH SE1 30 VO 사용자 설명서
5. DELIVERY SET
1. Electric storage water heater 1 pc.
2. Pressure safety valve 1 pc.
3. Mounting strip for hanging/mounting of water heater 1 pcs.
4. Instruction manual 1 pc.
5. Guarantee card 1 pc.
6. Packing 1 pc.
1. Electric storage water heater 1 pc.
2. Pressure safety valve 1 pc.
3. Mounting strip for hanging/mounting of water heater 1 pcs.
4. Instruction manual 1 pc.
5. Guarantee card 1 pc.
6. Packing 1 pc.
6. WATER HEATER INSTALLATION
Location
1. The water heater of SWH SE1 VO series can be installed over a
Location
1. The water heater of SWH SE1 VO series can be installed over a
washbasin, a kitchen sink or in any other place where it will not hinder
you. Please, note, that pipes must be placed on the bottom part of
water heater.
2. The water heater of SWH SE1 VU series can be installed under a
2. The water heater of SWH SE1 VU series can be installed under a
washbasin, a kitchen sink or in any other place where it will not hinder
you. Please, note, that pipes must be placed on the top part of water
heater.
3. Electric water heater should be mounted on a firm wall.
4. The wall where the electric water heater is to be mounted must
3. Electric water heater should be mounted on a firm wall.
4. The wall where the electric water heater is to be mounted must
withstand at least the double weight of the water heater fully filled with
water. There must be no cracks and other damages on the wall.
Otherwise, it is necessary to take measures to strengthen the mounting or
install the water heater on a special support.
5. If a bathroom is too small the water heater can be installed in any other
5. If a bathroom is too small the water heater can be installed in any other
place unexposed to direct sunlight and beyond the reach of moisture.
However, to reduce heat losses in pipelines the location where the water
heater is to be installed must be as close to the place of hot water use as
possible.
ENGLISH
5
www.timberk.com electric storage water heater
1. Power cord
2. Temperature controller handle
3. Inlet nozzle*
4. Outlet nozzle*
5. HEATING indicator lamp
6. Face panel cover
7. Back panel
8. Inner tank
9. Face panel
10. Temperature controller pipe
11. Heating element
12. Thermal insulation
13. Groove for the hanging/mounting of water heater
14. Magnesium anode
(through the example of SWH SE1 15 VO model)
* SWH SE1 VU series requires upper connection of water inlet and outlet; nozzles in this model are
located in the upper part of the water heater.
4. WATER HEATER DESCRIPTION
Fig. 6
Fig. 5
1
2
3*
Fig. 4
4*
5
6
8
9
7
10
11
12
14
13
13*