Bosch TDS 2215 사용자 설명서

19

BOSCH

1. After ironing, pull out the plug and allow the 

appliance to cool down before cleaning.

2. Wipe the housing, handle and iron body with a 

damp cotton cloth.

3. If the soleplate is soiled with dirt or scale, clean 

it with a damp cotton cloth.

4. If the cloth is synthetic, it may melt due to the 

high temperature on the soleplate (20). Switch 

off the steam and rub off any residue 

immediately with a thickly folded, dry cotton 

cloth.

5. Never use abrasive products or solvents. To 

keep the soleplate (20) smooth, you should 

avoid hard contact with metal objects. Never 

use a scouring pad, or chemicals to clean the 

soleplate.

1. Always allow the appliance to cool down before 

storing it.

2. Set the main power button to the “0” position 

(the red light will go off) and disconnect the 

mains cable.

3. Empty the water tank.

4. Place the iron on the iron pad (2), standing on 

the soleplate, and fix it by inserting the tip of 

the iron into the front slot and moving the lock 

lever (14) against the heel of the iron.

5. Store the mains cable in the storage 

compartment (5) and the steam hose in the 

storage fixing (3). Do not wrap the cords too 

tight.

6. Use the iron´s handle when moving the 

appliance, as shown in figure G.

This procedure helps to remove scale particles 

out of the steam chamber. 

This cleaning procedure may be performed 

occasionally (approximately once a year), when 

after a long period of use with very hard water, 

scale particles start to come out of the soleplate.

a) Ensure that the iron is cooled down.

b) Set the temperature selector (16) of the iron to 

the “min” position. 

c) Fill the tank with tap water. 

d) Plug in the mains cable and set the main 

power switch (13) to the “I” position.

e) Wait until the “steam ready” indicator lamp (9) 

lights up. 

f) If the steam station has steam regulator (11*), 

set it to the maximum position  . 

g) Hold the iron over the sink or a container to 

collect the water.

h) Press the steam release button (17) and gently 

shake the iron. Boiling water and steam will 

come out, carrying scale and or deposits that 

might be there. This could take approximately 5 

minutes.

i) Set the temperature selector (16) of the iron to 

the “max” position, without pressing the steam 

release button (17). The water in the steam 

chamber will start evaporating. Wait until all the 

water inside the chamber has been evaporated.

j) To clean the soleplate, immediately rub off any 

residue by running the hot iron over dry cotton 

cloth.