Dimplex Opti-V (1 стекло) (64907680) 사용자 설명서

다운로드
페이지 10
Introduction
Thank you for chosing this Dimplex Opti-V fi re. Please read 
information guide carefully to be able to safely install, use 
and maintain your product. The appliance is designed to be 
installed into a cabinet or wall opening.
Important Safety Advice
When using electrical appliances, basic precautions should be 
followed to reduce the risk of fi re, electric shock, and injury to 
persons, including the following:
If the appliance is damaged, check immediately with the supplier 
before installation and operation.
Do not use this appliance in the immediate surroundings of a 
bath, shower or swimming pool.
Means for disconnection must be incorporated in the fi xed wiring 
in accordance with the wiring regulations.
Do not use outdoors.
In the event of a fault switch off the appliance.
Switch off the appliance when not required for long periods.
If the supply cord is damaged, it must be replaced by a special 
cord or assembly available from the manufacturer or its service 
agent.
Warning - No naked fl ame sources, such as candles, should be 
placed on this apparatus.
Warning - The appliance shall not be exposed to dripping or 
splashing and that no objects fi lled with liquid, such as vases, 
shall be placed on the apparatus.
Warning - this appliance is of Class I construction and must be 
connected to a mains outlet with protective earthing connection.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED 
Do not switch the appliance on until properly installed.  Please 
read all the safety warnings and operating instructions.
General
Unpack the appliance carefully and retain the packaging for 
possible further use, in the event of moving or returning the 
appliance to the supplier.
Contents of Carton
•    
Opti-V Fire Model PGF10
•    
Remote control and batteries (AAA type)
Product Features
Volume Control
Remote or Manual operation 
Red light indication of standby mode
Installation
Warning.
Do not connect the appliance until properly fi xed to a secure 
base and the instruction leafl et is read fully.
At installation of the appliance, care must be taken not to 
damage any cables that may be concealed in the wall.
Positioning the Fire
The Opti-V uses an illusory refl ection technique and is designed 
to work best when ambient light levels are low. If the Opti-V is 
installed in brightly lit areas, the strong refl ections may diminish 
the fl ame picture.
Opti-V Fire : PGF 10
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Fixing dimensions
The Opti-V is supplied in an assembled state.
This model is designed to be permanently fixed. 
Please see Fig.2a and 2b for recommended fi xing dimensions.
Height of Fire
There is a choice of height when fi tting the fi re. 
Recommended heights (from fl oor to bottom opening of fi re - * 
Fig 2a) :
- Minimum 65cm when the fi re is viewed while sitting 
(e.g. lounge).
- Maximum 110cm when the fi re is viewed while standing 
(e.g. reception area).
Electrical connection
The outline of the chassis and the position of the electrical socket 
are shown as dotted outlines in Fig.4. Please consult  with a 
qualifi ed electrician for appropriate wiring requirements.
Operation: -
The power ‘ON’ switch (‘O/I’see Fig.3) must fi rst be switched ‘I’ 
to operate the appliance.
An ‘Opti-V’ screen will appear for about 3 seconds before the 
fl ame picture starts .
Note: The user may notice a blank screen for approximately 5 
seconds, every 30 minutes. This is normal and should not be a 
cause for concern.
Manual Control Operation: -
The manual controls for the screen are located at the inner top 
left hand side of the appliance above the glass.(see Fig.3). 
The appliance Power switch (‘O/I’ see Fig.3) may be used to 
switch the appliance off (‘O’) when it is not required,  for example, 
overnight or for long periods, to avoid energy wastage.
The standby button (    ) is located just below the mains switch.
 
Screen Brightness:-
The screen brightness can be adjusted using the 
 
and 
  
buttons. These are located at the inner top, just above the glass 
(see Fig.3). The 
 button darkens the screen and the  
 button 
brightens the screen. 
Remote Control Operation: -
The remote control may be operated once the appliance is 
switched ‘I’ (‘I’ see Fig.3).
 
Aim the remote control at the fi re (the sensor is indicated in Fig. 
4
). The volume may be adjusted up or down by pressing the  
volume control buttons ( + and -). 
The button funtions are identifi ed as described below;
       Standby
  -   Volume down
    Volume up
A red light will indicate when the appliance is in standby mode. 
(see Fig 4)
1