Cisco Cisco UCS B440 M1 High-Performance Blade Server 기술 매뉴얼

Contributed by Padmanabhan Ramaswamy and Shankar Prasath, Cisco
TAC Engineers.
Mar 06, 2015

Introduction
Prerequisites
     Requirements
     Components Used
Background Information
Configure
     FI Configuration
     Access the UCSM Via IPv6
     CIMC Over IPv6
     Launch the KVM Console and Other Services
Verify
     Verify the IPv6 Address Assignment for the FIs
     Test Basic Network Connectivity
     Verify the IPv6 Address Assignment for the CIMC
     Trace the CIMC Inband Connection Path for Blade Servers
     Trace the CIMC Inband Connection Path for Rack Servers
Troubleshoot
Frequently Asked Questions (FAQs)
     Can I use IPv6 Private Unicast addresses for the management port?
     Does UCS support Stateless Address Autoconfiguration (SLAAC)?
     Can I use IPv6 for iSCSI initiators when I use iSCSI boot?
     What happens when the UCSM is downgraded from UCS Version 2.2 or later to UCS Version 2.1 or
earlier?
     What happens when the FI is downgraded from UCS Version 2.2 or later to UCS Version 2.1 or earlier?
     What happens when the CIMC uses UCS Version 2.1 or earlier?
     What happens when the CIMC is downgraded from UCS Version 2.2 or later to UCS Version 2.1 or
earlier?
     Are there any reserved prefixes that cannot be used for IPv6 addresses?
     Are there any reserved VLANs that cannot be used for Inband management?
Related Information

This document describes how to configure the Cisco Unified Computing System (UCS) management
end−points with IPv6 addresses.

Cisco recommends that you have knowledge of these topics: