Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
3
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(15)XR
OL-6047-01
System Requirements
On access points running IOS software, you can also find the software version on the System Software
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Version page in the access point’s web-browser interface. If your access point does not run IOS software,
the software version appears at the top left of most pages in the web-browser interface.
Upgrading to a New Software Release
For instructions on installing access point software:
1.
Follow this link to the Cisco Support page:
2.
Follow this path to the product, document, and chapter:
Aironet 1200 Series Wireless LAN Products > Cisco Aironet 1200 Series Access Points >
Aironet 1200 Series Access Points, Cisco IOS Release 12.2(15)JA > Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points > Managing Firmware and
Configurations > Working with Software Images
Aironet 1200 Series Wireless LAN Products > Cisco Aironet 1200 Series Access Points >
Aironet 1200 Series Access Points, Cisco IOS Release 12.2(15)JA > Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points > Managing Firmware and
Configurations > Working with Software Images
3.
Click this link to browse to the Cisco IOS Software Center on Cisco.com:
Log into Cisco.com to use the Cisco IOS Upgrade Planner.
Converting to Cisco IOS Software
If your 350 or 1200 series access point does not run IOS software, you can use the conversion utility or
the conversion upgrade image to convert the access point system to IOS software. Use the conversion
utility to maintain the current configuration after the conversion, or load the upgrade image to convert
to IOS software without saving the current configuration. Your access point must be running one of these
VxWorks firmware versions before you can convert to IOS software:
the conversion upgrade image to convert the access point system to IOS software. Use the conversion
utility to maintain the current configuration after the conversion, or load the upgrade image to convert
to IOS software without saving the current configuration. Your access point must be running one of these
VxWorks firmware versions before you can convert to IOS software:
•
350 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 11.23T, or
11.21
11.21
•
1200 series access points must be running VxWorks version 12.03T, 12.02T1, 12.01T1, 12.00T,
11.56, or 11.54T
11.56, or 11.54T
Note
The upgrade image and the conversion tool do not support VxWorks version 12.04. Access points
running version 12.04 must be downgraded to a supported operating system version before you can use
the upgrade image or the conversion tool.
running version 12.04 must be downgraded to a supported operating system version before you can use
the upgrade image or the conversion tool.
Note
The upgrade to Cisco IOS software is permanent; you cannot revert to non-IOS software. Product
warranties do not cover unintended upgrades.
warranties do not cover unintended upgrades.
For complete instructions on using the conversion utility, refer to the Cisco Aironet Conversion Tool for
Cisco IOS Software, 2.1 Administrator Guide for Windows. Click this link to browse to the Administrator
Guide:
Cisco IOS Software, 2.1 Administrator Guide for Windows. Click this link to browse to the Administrator
Guide: