Cisco Cisco PVC2300 Business Internet Video Camera - Audio PoE 관리 매뉴얼

Back Panel

Cisco PVC2300 and WVC2300 Internet Video Cameras with Audio Administration Guide

13

 

over the twisted-pair cable without requiring its own separate power source. This 
capability gives network administrators centralized power control, which 
translates into greater network availability.

To connect a device to the port, you will need to use Category 5 (or better) 
network cable.

NOTE FOR WVC2300: Attaching an Ethernet cable will disable the wireless 
interface on the WVC2300 camera. Only one interface can be active at any time.

NOTE FOR WVC2300: On the WVC2300 camera, the Ethernet cable should only be 
connected or disconnected when the camera is powered OFF. Attaching or 
detaching the Ethernet cable while the camera is powered on does NOT switch the 
interface between wired and wireless. In order to switch from wired to wireless or 
vice versa, the power needs to be disconnected and reconnected to change from 
one mode to the other. Disconnecting the Ethernet while power is on will merely 
disconnect the camera from the network.

The Activity LED flashes when activity is detected on the Ethernet port.

This LED only functions on the PVC2300 camera. The LED has the following states: 

•

On—PoE connection is detected.

•

Off—PoE connection is not detected.

On the back panel, the green LED is the PoE indicator and when on, indicates that 
you have PoE power. If you plug in the power supply, this LED will not light up. 
Another good indicator is if you happen to plug in both the PoE and regular power 
supply, if the green LED is on, this indicates you have PoE power and if not, it 
indicates you have lost power from your PoE switch.