Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) 릴리즈 노트

Set OSRI to OFF and click Apply. The amplifier stays turned off (this is expected, since in Manual 
Restart the lasers are turned back on by means of a Request Laser Restart command issued in CTC).

Select the Request Laser Restart check box in the Maintenance tab and click Apply.

The amplifier goes into APR for 9 seconds (correct), but after this it turns off; it should go into LASER 
ON state (State 4 at module level). If this issue occurs, change the card from manual restart to auto 
restart, then toggle OSRI ON and OFF. This issue is resolved in Release 7.2.

For nodes configured in multishelf mode using the default LAN configuration, SNMP traps are not sent 
to the management system. To avoid this issue, provision any the DCN-connected node as “Socks proxy,” 
then, on such nodes add the following static route: 

Destination: 0.0.0.0

Next hop: DCN Router

Cost: 10

Provision any non-DCN connected node as ENE.

A white paper/application note is in progress and can be requested from Cisco TAC. A documented 
solution is available in the ONS 15454 DWDM Procedures Guide.

The Calibration Tilt is not properly changed using the TL1 interface. The reference tilt is changed 
instead. This issue can be seen when you try to change the CALTILT parameter on amplifier cards using 
the ED-OTS command. To avoid this issue, use CTC. This issue is resolved in Release 7.2.

This section highlights new features and functionality for Releases 7.0.x. For detailed documentation of 
each of these features, consult the user documentation.