Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드
Connect Using the KVM Port
1.
Connect the Ethernet LAN cable from the LAN 1 port on the rear of the unit to your network.
The LAN 1 port is the left-hand port of the dual port adapter (shown in
).
2.
Either:
—
Connect a USB keyboard and VGA monitor using a KVM adaptor to the KVM connector on the front panel (see
).
—
Connect a USB keyboard to the USB port and a VGA monitor to the VGA port on the rear panel (see
).
You can now proceed to configure the Cisco VCS.
Configure the Cisco VCS
If the system has just booted up, the terminal emulator program on the PC will display the Cisco VCS’s startup
information. After approximately four minutes you will get the login prompt. If the Cisco VCS was already on when you
connected the serial cable, press
information. After approximately four minutes you will get the login prompt. If the Cisco VCS was already on when you
connected the serial cable, press
Enter
to get the login prompt.
1.
Enter the username
admin
and press
Enter
.
2.
Enter the default password of
TANDBERG
and press
Enter
.
You will get the install wizard prompt:
Run install wizard [n]:
3.
Type
y
and press
Enter
.
4.
Follow the prompts given by the install wizard to specify the following:
—
The password you want to use for your admin account.
Note:
For security reasons you are advised to change the password from the default of
TANDBERG
.
—
Whether you want to use IPv4, IPv6 or Both .
—
The LAN 1 IP address of the Cisco VCS.
—
The LAN 1 IPv4 subnet mask of the Cisco VCS (if you have selected IPv4).
—
The IP address of the default gateway of the Cisco VCS.
—
The Ethernet speed.
Note:
Use the default value of
Auto
, but ensure that the SFP is connected to a switch at the correct speed (1
Gb if connecting to the copper SFPs or 10 Gb if connecting to the fiber SFPs).
—
Whether you want to use SSH to administer the Cisco VCS.
5.
After the wizard is finished the following message will appear:
Setting other settings...OK.
The system must be restarted for new
settings to take effect..
settings to take effect..
You will get a restart prompt:
Restart Now?
Type
y
and press
Enter
.
6.
After it has rebooted, the Cisco VCS is ready to use. You can access the Cisco VCS's web interface using the IP
address assigned to the LAN 1 Ethernet port.
address assigned to the LAN 1 Ethernet port.
Note:
For security reasons you are advised to change the password for the
(if you have not
already done so) and the
from the default of TANDBERG.
8
Cisco Video Communication Server CE1000 Appliance Installation Guide