Cisco Cisco UCS B440 M1 High-Performance Blade Server 기술 매뉴얼
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Diagram
Configurations
Sniffer VM with an IP address
Sniffer VM without an IP address
Failure scenario
Related information
Introduction
This document describes the steps to capture a traffic flow that is completely outside the Cisco
Unified Computing System (UCS) and direct it to a Virtual Machine (VM) running a sniffer tool
inside the UCS.
Unified Computing System (UCS) and direct it to a Virtual Machine (VM) running a sniffer tool
inside the UCS.
The source and destination of the traffic being captured is outside the UCS. The capture can be
initiated on a physical switch that is directly attached to the UCS or it could be a few hops away.
initiated on a physical switch that is directly attached to the UCS or it could be a few hops away.
Prerequisites
Requirements
Cisco recommends that you have a working knowledge of these topics:
Cisco Unified Computing System (UCS)
●
VMware ESX version 4.1 or later
●
Encapsulated Remote Switch Port Analyzer (ERSPAN)
●
Components Used
The information in this document is based on these software and hardware versions:
Cisco Catalyst 6503 running 12.2(18)ZYA3c
●
Cisco UCS B series running 2.2(3e)
●
VMWare ESXi 5.5 build 1331820
●
Background Information
UCS does not have the Remote SPAN (RSPAN) feature to receive SPAN traffic from a connected