Cisco Cisco PVC2300 Business Internet Video Camera - Audio PoE 설치 가이드
Quick Start Guide
Cisco Small Business
Models PVC2300 and WVC2300
Internet Video Camera with Audio
Models PVC2300 and WVC2300
Internet Video Camera with Audio
Package Contents
• 2300 Series Camera
• Stand Kit
• Power Supply (12V 1A)
• 6-Foot Ethernet Cable
• Lens Adapter Ring
• Allen Wrench
• Antenna (WVC2300)
• Setup and Documentation CD-ROM
Before You Begin
• To configure the Cisco PVC2300 and WVC2300 cameras, you need at least
one computer with an active LAN IP connection.
• You must perform the initial configuration of the Cisco WVC2300 camera
from a personal computer connected to the camera using a wired
connection to the Ethernet port. The initial configuration cannot be
performed over a wireless connection.
connection to the Ethernet port. The initial configuration cannot be
performed over a wireless connection.
Once the hardware installation is complete, Cisco strongly recommends that
you run the Setup Wizard on the Setup CD-ROM for first-time software
installation of the camera. Advanced users can set up the Cisco PVC2300 and
WVC2300 cameras directly from the web interface of the camera.
you run the Setup Wizard on the Setup CD-ROM for first-time software
installation of the camera. Advanced users can set up the Cisco PVC2300 and
WVC2300 cameras directly from the web interface of the camera.
1
Camera Installation
Follow these steps to install the camera.
S
TEP
1
(Optional) Attach the base of the camera stand to a permanent
location by using the three included screws.
location by using the three included screws.
S
TEP
2
Assemble the camera stand in one of the following ways:
• Attach the swivel head directly to the stand base.
• If an extension is necessary, attach the camera extension to the stand base
and then attach the swivel head to the extension.
S
TEP
3
Connect the camera stand to the bottom of the camera.
S
TEP
4
Adjust the camera to the appropriate viewing position and secure the
camera in place by tightening the locknut.
camera in place by tightening the locknut.
2
S
TEP
5
Connect the included Ethernet network cable to your network router or
switch.
switch.
S
TEP
6
Connect the other end of the cable to the camera Ethernet port.
N
OTE
If your network switch provides Power over Ethernet (PoE),
proceed to step 8. The PoE function applies to the PVC2300
camera only.
proceed to step 8. The PoE function applies to the PVC2300
camera only.
S
TEP
7
If your network switch does not provide PoE, connect the included
power adapter to the camera’s Power port and plug the other end into
a standard electrical outlet.
power adapter to the camera’s Power port and plug the other end into
a standard electrical outlet.
S
TEP
8
Verify that the camera LEDs are lit.
The
PVC2300 and WVC2300
cameras have two LEDs to let you know how
the camera is functioning.
LED
Color
Activity
Action
Ready
Amber
Off
Camera is powered off.
On
Camera is powered on.
Blink
Camera is booting.
Network
Green
Off
Network connection not detected.
On
Network connection detected.
Blink
Sending and receiving data.