Cisco Cisco UCS B440 M1 High-Performance Blade Server 기술 매뉴얼

Introduction
 Prerequisites
      Requirements
      Components Used
      Network Diagram
      Conventions
 Background Information
 Main Task
      Task
      1. Upgrade BIOS on a UCS Server Blade with the GUI
      2. Upgrade BIOS on a UCS Server Blade with the CLI
 Verify
 Troubleshoot
 Related Information

In order to upgrade the BIOS on a Server Blade or a Server Pool, you complete five major steps:

Verify/confirm that the correct BIOS is present in the fabric interconnect flash.

1. 

Create a Host Firmware Package policy.

2. 

Associate the Host Firmware Package policy with a Service Profile.

3. 

Associate the Service Profile with the server blade or server pool.

4. 

Verify the BIOS version of the blade matches the BIOS for the Host Firmware Package policy.

5. 

This tech note addresses how to upgrade the BIOS on a Server Blade or a Server Pool with one of these
methods:

Cisco UCS Manager GUI

• 

Cisco UCS Manager CLI

• 

Note: You cannot update the BIOS firmware directly. You must perform the BIOS firmware update through a
host firmware package in a service profile. If the BIOS fails, it can recover and boot from the ISO image that
is shipped with the server.

Cisco recommends that you:

Have a working knowledge of Cisco UCS Server Blade software and hardware.

• 

Be familiar with the UCS manager GUI.

• 

Understand the impact and implications of the different commands described in this document

• 

Be familiar with the UCS components and topology. Refer to the diagram for a typical solution

•