Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) 릴리즈 노트

Enables or disables the SW-LCAS H4 byte sequence number re-sequence feature. If an ML-Series card 
running Software Release 4.6.2 or later is interoperating with an ML-Series card running Software 
Release 4.6.0 or 4.6.1, then the 

command must be added to the 

configuration of the ML-Series card running Software Release 4.6.2 or later.

The default setting is Enable.

Per POS port configuration

The no form of the command will set the mode to the default. 

The following example disables the re-sequencing of the H4 byte sequence numbers for POS port 0:

Router(config)#

Router(config)#

The following items are resolved in Release 4.6.6

Pulling the active XCVXL card might result in a traffic outage lasting for greater than 2 seconds. It is 
possible to see this approximately 1 out of every 7 active XCVXL card pulls. Excessive traffic outage 
from this issue will not occur after a software-induced XCVXL side switch. In this case, you can expect 
a traffic hit of less than 60 ms, and traffic will resume normally. This issue is resolved in Release 4.6.3.

Enable 

Enables the re-sequencing of the H4 byte sequence numbers when a 
member is added to the VCAT group or removed from the VCAT group. 
If both members are up, then member #0 will have sequence number of 
zero (0) and member #1 will have sequence number one (1). If only one 
member is up, then the sequence number of that member will be zero (0).

Disables

Disables the re-sequencing of the H4 byte sequence numbers when a 
member is added to the VCAT group or removed from the VCAT group. 
Member #0 will always have a sequence number of zero (0) and member 
#1 will always have a sequence number of one (1)