Cisco Cisco ONS 15454 SDH Multiservice Provisioning Platform (MSPP) 릴리즈 노트
36
Release Notes for Cisco ONS 15454 SDH Release 4.6.6
OL-4855-01
New Features and Functionality
Step 3
View the PCA path level counts shown in CTC.
Step 4
Clear the Forced Switch Ring in CTC. The MS-SPRing switches back to working; however, IPPM path
level counts for PCA circuits are not shown.
level counts for PCA circuits are not shown.
To recover from this situation, lock out the ring by issuing the LockoutOfProtection (LK-S) command
on both east and west for all nodes in the ring. Reboot the OCn card that is not showing PCA path level
counts. This procedure needs to be performed whenever there is a switch in MS-SPRing configuration.
This issue is resolved in Release 4.6.
on both east and west for all nodes in the ring. Reboot the OCn card that is not showing PCA path level
counts. This procedure needs to be performed whenever there is a switch in MS-SPRing configuration.
This issue is resolved in Release 4.6.
SNCP Functionality
CSCea23732
If you try to manually create a VC4 circuit over a three node, STM4 SNCP using automatic routing and
a required node, but there is no protected path from the source to the destination excluding the required
node, automatic routing will fail to find a path and will raise a “ComputeRouteInMixedDomains: No
Route Found” exception. To avoid this issue, you can avoid selecting required nodes, or use manual
routing. This issue is resolved in Release 4.6.
a required node, but there is no protected path from the source to the destination excluding the required
node, automatic routing will fail to find a path and will raise a “ComputeRouteInMixedDomains: No
Route Found” exception. To avoid this issue, you can avoid selecting required nodes, or use manual
routing. This issue is resolved in Release 4.6.
CSCec04550
In a SNCP configuration, upon detecting a double-path failure with UNEQ-P, the UNEQ-P on the protect
path is not reported. This issue is resolved in Release 4.6.
path is not reported. This issue is resolved in Release 4.6.
Performance Monitoring
CSCec63978
The clear button on the PM pane in CTC does not clear PJ detected seconds, PJ generated seconds, or
PJ diff. Clearing PMs should result in the associated cell being marked yellow (INVALID) and zero;
however, for PJ detected seconds, PJ generated seconds, and PJ diff, the cells remain unchanged.
PJ diff. Clearing PMs should result in the associated cell being marked yellow (INVALID) and zero;
however, for PJ detected seconds, PJ generated seconds, and PJ diff, the cells remain unchanged.
There is no workaround for PJ seconds. These will continue to accumulate where they left off and not
be marked invalid. PJ diff should be marked invalid, but is recalculated to the correct value, and is
displayed as such. This issue is resolved in Release 4.6.2.
be marked invalid. PJ diff should be marked invalid, but is recalculated to the correct value, and is
displayed as such. This issue is resolved in Release 4.6.2.
CSCea38791
In the CTC Performance > Statistics tab of the G1000-4 or G1000-2, there are no entries for Rx/Tx
Multicast and Broadcast packets. This issue is resolved in Release 4.6.
Multicast and Broadcast packets. This issue is resolved in Release 4.6.
New Features and Functionality
This section highlights new features and functionality for Release 4.6.x. For detailed documentation of
each of these features, consult the user documentation.
each of these features, consult the user documentation.