Cisco Cisco 5520 Wireless Controller 기술 참조
30
Cisco Virtual Wireless Controller Deployment Guide, Release 7.5
Deploying Virtual WLC on SRE Service Modules 710/910 for ISR-G2
*Aug 1 17:52:51.811: %SRE_SM-6-STATE_CHANGE: SM1/0 changing state from
SERVICE_MODULE_STATE_ERRQ to SERVICE_MODULE_STATE_STDY
*Aug 1 17:53:02.799: %SM_INSTALL-6-INST_PROG: SM1/0 PROGRESSING: Validating package
signature ....
*Aug 1 17:53:02.915: %SM_INSTALL-6-INST_PROG: SM1/0 PROGRESSING: Parsing package
manifest files ....
*Aug 1 17:53:19.811: %SM_INSTALL-6-INST_PROG: SM1/0 PROGRESSING: Starting payload
download.
*Aug 1 17:53:21.067: %SM_INSTALL-6-INST_PROG: SM1/0 PROGRESSING: Starting payload
download.
*Aug 1 17:53:51.143: %SM_INSTALL-6-INST_PROG: SM1/0 PROGRESSING: Performing Hot install
....
*Aug 1 17:54:53.483: %SM_INSTALL-6-INST_PROG: SM1/0 PROGRESSING: Updating BIOS sata mode
to ahci .
Install successful on SM1/0. Please wait for module to reset before next operation.
<<SUCCESS>>
*Aug 1 17:55:01.395: %SM_INSTALL-6-INST_SUCC_RESET: SM1/0 SUCCESS: install-completed.
Please wait for module to reset before next operation
*Aug 1 17:55:15.247: %DTP-5-NONTRUNKPORTON: Port SM1/1 has become non-trunk
*Aug 1 17:55:16.247: %DTP-5-TRUNKPORTON: Port SM1/1 has become dot1q trunk
*Aug 1 17:56:30.803: %SM_INSTALL-6-INST_RBIP: SM1/0 received msg: RBIP Status Req
*Aug 1 17:56:30.803: %SM_INSTALL-6-RBIP_STATUS: SM1/0 RBIP status is at Secondary
Bootloader Verified Copying to Primary.
*Aug 1 17:57:02.439: %SM_INSTALL-6-INST_RBIP: SM1/0 received msg: RBIP Registration
Request
*Aug 1 17:57:02.439: %SM_INSTALL-6-INST_RESET_COMP: SM1/0: Module reset complete.
Step 7
To show the status of the service module.
a.
Type in the command
service-module sm 1/0 status
Router#service-module sm 1/0 status
Service Module is Cisco SM1/0
Service Module supports session via TTY line 67
Service Module is in Steady state
Service Module heartbeat-reset is enabled
Getting status from the Service Module, please wait..
Cisco SRE-V Software 2.0.1.0
VMware ESXi 5.0.0 build-474610 running on SRE
<<This shows VMware Hypervisor has been
installed>>
No install/uninstall in progress
Connecting to Hypervisor on the SRE 710/910 Service Module on ISR G2
Step 8
Console access to hypervisor from the router with the command
service-module <sm number> session
a.
Note that VMware Hypervisor has been installed, showing on a CISCO SRE.
b.
The IP address has been defined by the command in the interface configuration steps
service-module ip address
Router#service-module sm 1/0 session