Cisco Cisco VC220 Dome Network Camera 관리 매뉴얼
Sample Configurations for the Cisco VC 220 Network Camera
Configuring the GPIO Ports
VC 220 Dome WDR Day/Night PoE Network Camera Administration Guide
96
8
Configuring the GPIO Ports
The following instructions help you configure the general input and output (GPIO)
on the Cisco VC220 camera. In general, you will need to:
on the Cisco VC220 camera. In general, you will need to:
•
Make the GPIO connections and test the external device connections. See
for
connection diagrams and further information.
•
Setup an event.
Consider the following example:
STEP 1
Make and test the output GPIO connection. For this example, we are using an
alarm as an output device.
alarm as an output device.
a. Connect the output device (alarm) to pin 1 and pin 2.
b. Go to the Camera Control > I/O Port page to select the proper Default State
for the output port.
c. Go to the View Video page
d. Click the On button on the View Video page. The alarm should turn on.
e. Click the Off button on the View Video page. The alarm should turn off.
f.
Go to the Status> System Summary page. I/O Port Status should show the
output as Triggered when the alarm is on and Normal when the alarm is off.
output as Triggered when the alarm is on and Normal when the alarm is off.