Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드

DPM Default Settings for Different Output Modes

381

DPM Default Settings for Different Output Modes

The DPM parameters are preset to default settings for each DPM Output Mode.

The default settings for particular Output modes have  been preset to optimize the
output when  PID mapping is required.  If the DPM parameters are changed to values
which  switch the receiver  to Full DPM Control,  the receiver  may enter  a condition
where  conflicts in the settings may occur, which  may require  manual manipulation
of the DPM or output parameters to obtain the desired  output.

The fields labeled “Any” in the table below are not used, in which  case, the Output
Mode will  not change  if the parameter is changed.  However,  if you change  any of
the other parameters listed in the table for the MAP output modes, the Output Mode
will change  to Full DPM Control.

Output Mode No Output

Passthrough

Service
Chans Only

MAP
Passthrough

MAP Svc
Chans Only

Full DPM
Control

Rate Control

Any
(unchanged)

User Rate

Any
(unchanged)

Descramble
Mode

Any
(unchanged)

Regenerate

Any
(unchanged)

Insert Null
Packet

Any
(unchanged)

Map Mode

Any (not
used)

Svc ID

Svc Id & PID Svc ID & PID Actual

Value

Duplic Mode Any (not

used)

PSI Remap

Pkt Copy

Actual
Value

Unref

Drop

Pass

Drop

Pass

Drop

Actual
Value

PSI Options

Drop

Ctl By Table

Actual
Value

PSI Rate

Any (not
used)

SA Std

Actual
Value

Svc ID

Any (not
used)

Valid Ch

Actual
Value

PAT

Not
Displayed

Pass

Regen

Actual
Value