Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Chapter 3 Installation
26
Connector
Interface type
Connector type
SMPTE-292M
BNC female
Connecting the Component Video Output
Connect a video monitor to the connectors labeled Pr, Pb, and Y.
Connecting the Composite Video Output
Connect a video monitor to the CVSB 1 and CVSB 2 connectors. The two outputs are
identical. Use a 75-ohm double-braided coax cable.
identical. Use a 75-ohm double-braided coax cable.
Connecting the Balanced Audio Outputs
1 Connect the AUDIO 1 and AUDIO 2 balanced audio outputs to monitoring
equipment. Use a multi-conductor, pluggable cable from the receiver's AUDIO 1
and AUDIO 2 (Left and Right) terminals to your equipment, as shown in the
following illustration.
and AUDIO 2 (Left and Right) terminals to your equipment, as shown in the
following illustration.
Connector
Connector type
Terminal Block
2 Feed the stripped ends of the positive, negative and ground wires into the
appropriate terminals as labeled, and then screw the terminal screws (located on
the top of the terminal block) finger tight to each wire.
the top of the terminal block) finger tight to each wire.
Connecting the Ethernet Management Interface
The RJ-45 interface for 100/1000 BaseT Ethernet is currently intended for
upgrading/downloading the software application. You must set up the IP address,
the default gateway and the subnet mask to match the network connection. This is
done through the front panel menu. For further information, see Setting up for
Network Connection (on page 13).
upgrading/downloading the software application. You must set up the IP address,
the default gateway and the subnet mask to match the network connection. This is
done through the front panel menu. For further information, see Setting up for
Network Connection (on page 13).