Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Setup Menu
71
Menu Item
Description
Parameters
LNB Power
Set the power output of RF1 to the external
LNB.
LNB.
Off, 13V, 18V, V-NIT, or
H-NIT.
H-NIT.
V-NIT and H-NIT will use
vertical and horizontal
polarity until it is
automatically read from
the NIT.
Note: Power will not be
applied to the LNB when
set to Off.
polarity until it is
automatically read from
the NIT.
Note: Power will not be
applied to the LNB when
set to Off.
22kHz
For dual band applications, select whether to
transmit the 22 kHz tone Local Oscillator
control signal of RF1.
control signal of RF1.
On, Off, or Auto.
Auto uses the crossover
frequency to determine if
the tone is transmitted.
the tone is transmitted.
IP Input
Menu Item
Description
Parameters
IP1 Active
Select the input to be active.
Note: Setting a new input to be active will
deactivate the currently active input.
Note: Setting a new input to be active will
deactivate the currently active input.
Act or No
Tune Mode
Select which tables are required for the service
list creation and signal acquisition.
Note: When editing the tuning, the device is in
a transient state while acquiring tuning
list creation and signal acquisition.
Note: When editing the tuning, the device is in
a transient state while acquiring tuning
information and channel lists, and so on. The
receiver reverts to the previous set of tuning
settings/information and channels until these
changes are either saved or abandoned.
receiver reverts to the previous set of tuning
settings/information and channels until these
changes are either saved or abandoned.
Basic - Requires NIT to be
present.
present.
Auto - Uses all the service
list tables and it will
list tables and it will
acquire if any service list
tables are present.
tables are present.
Custom - Uses the Custom
Tuning parameters,
specified by the user.
specified by the user.
The default is Basic.