Cisco Cisco Email Security Appliance C160 기술 참조

In this example, a new configuration file is pasted directly at the command line. (Remember to type 
Control-D on a blank line to end the paste command.) Then, the system setup wizard is used to change 
the default hostname, IP address, and default gateway information. Finally, the changes are committed. 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now.

Press CTRL-D on a blank line when done.

[The configuration file is pasted until the end tag </config>. Control-D 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> systemsetup

mail3.example.com> commit

Please enter some comments describing your changes:

[]> pasted new configuration file and changed default settings via