Cisco Cisco ASA 5505 Adaptive Security Appliance 기술 매뉴얼

Introduction
 Prerequisites
      Requirements
      Components Used
      Related Products
      Conventions
 Background Information
 Configurations
      Configure the ASA/PIX as a Remote VPN Server with ASDM
      Configure the ASA/PIX to NAT Inbound VPN Client Traffic with ASDM
      Configure the ASA/PIX as a Remote VPN Server and for Inbound NAT with the CLI
 Verify
      ASA/PIX Security Appliance − show Commands
 Troubleshoot
 Related Information

This document describes how to configure the Cisco 5500 Series Adaptive Security Appliance (ASA) to act as
a remote VPN server using the Adaptive Security Device Manager (ASDM) or CLI and NAT the Inbound
VPN Client traffic. The ASDM delivers world−class security management and monitoring through an
intuitive, easy−to−use Web−based management interface. Once the Cisco ASA configuration is complete, it
can be verified through the Cisco VPN Client.

This document assumes that the ASA is fully operational and configured to allow the Cisco ASDM or CLI to
make configuration changes. The ASA is also assumed to be configured for Outbound NAT. Refer to Allow
Inside Hosts Access to Outside Networks with the use of PAT for more information on how to configure
Outbound NAT.

Note: Refer to Allowing HTTPS Access for ASDM or PIX/ASA 7.x: SSH on the Inside and Outside Interface
Configuration Example to allow the device to be remotely configured by the ASDM or Secure Shell (SSH).

The information in this document is based on these software and hardware versions:

Cisco Adaptive Security Appliance Software version 7.x and later

• 

Adaptive Security Device Manager version 5.x and later

•