Cisco Cisco TelePresence Video Communication Server Expressway 릴리즈 노트
encryption, you must perform a factory reset. Proceed as follows to ensure you can upgrade in future:
1.
Record all your software configuration details
2.
Upgrade the software with the AES-encryption version
All configuration will be lost
3.
Perform a factory reset
4.
Manually reconfigure the software
Upgrade Instructions
When maintenance mode is enabled on Cisco VCS, existing calls passing through it may be dropped. We recommend
that you upgrade Cisco VCS components while the system is inactive.
that you upgrade Cisco VCS components while the system is inactive.
If you are upgrading a Cisco VCS that uses clustering, device provisioning (Cisco TMSPE) or FindMe (with Cisco TMS
managing Cisco VCS), you must follow the directions in Cisco VCS Cluster Creation and Maintenance Deployment
Guide.
managing Cisco VCS), you must follow the directions in Cisco VCS Cluster Creation and Maintenance Deployment
Guide.
Follow the procedure below for upgrading Cisco VCS to X8.7.1, only if all of the following apply:
■
The Cisco VCS is not part of a cluster
■
Device provisioning is not in use
■
Cisco TMS is not managing the Cisco VCS
■
Cisco VCS is currently running X5.1.1 or later
To upgrade a Cisco VCS:
1.
Backup the Cisco VCS (Maintenance > Backup and restore).
You should backup your system before upgrading. If you later need to downgrade to an earlier release you will
have to restore a backup made against that previous release.
have to restore a backup made against that previous release.
If your system was delivered with X6.1 pre-installed, you must make some configuration changes before using
the backup process as described in the section below.
the backup process as described in the section below.
2.
Enable maintenance mode.
Log in to the Cisco VCS as admin (SSH or serial), and at a command prompt, type:
xConfiguration SystemUnit Maintenance Mode: On
Note that from X8.1 you can enable maintenance mode via the web interface (Maintenance > Maintenance
mode).
mode).
3.
Wait for all calls to clear and registrations to timeout.
—
If necessary, manually remove any calls that do not clear automatically (Status > Calls, click Select all and
then click Disconnect).
then click Disconnect).
—
If necessary, manually remove any registrations that do not clear automatically (Status > Registrations > By
device, click Select all and then click Unregister).
device, click Select all and then click Unregister).
4.
Upgrade and restart the Cisco VCS (Maintenance > Upgrade).
Note that when upgrading to a new major release, for example from X7.n to X8.n you need to supply a valid
release key as a part of the upgrade process.
release key as a part of the upgrade process.
The web browser interface may timeout during the restart process, after the progress bar has reached the
end. This may occur if the Cisco VCS carries out a disk file system check – which it does approximately once
every 30 restarts.
end. This may occur if the Cisco VCS carries out a disk file system check – which it does approximately once
every 30 restarts.
The upgrade is now complete and all Cisco VCS configuration should be as expected.
9
Cisco TelePresence Video Communication Server Release Note
Upgrading to X8.7.1