Cisco Cisco TelePresence Video Communication Server Expressway
Appendix 5: Deployment with TelePresence Conductor connected to Cisco Unified CM
Cisco TelePresence Multiway Deployment Guide (Cisco VCS X7.2 and Conductor XC2.2)
Page 39 of 41
SIP authentication
trust mode
trust mode
Off
Peer 1 address
FQDN of the Cisco Unified CM
Zone profile
Cisco Unified Communications Manager or Custom with Call signaling routed mode
set to Always.
set to Always.
2. Go to
VCS configuration > Dial plan > Search rules
and add a search rule with a conference alias that
points to the Cisco Unified CM SIP trunk. This is the conference alias that should match the Multiway
URI that a VCS-registered endpoint will dial. The search rule should have the following settings:
URI that a VCS-registered endpoint will dial. The search rule should have the following settings:
Name
Route to UCM
Priority
Enter a value appropriate to your dial plan.
Protocol
Any
Source
Any
Request must be authenticated
Configure this setting according to your authentication policy.
Mode
Alias pattern match
Pattern type
Regex
Pattern string
(3\d{3})@vcs.domain(.*)
Pattern behavior
Leave
On successful match
Stop
Target zone
CUCM neighbor
State
Enabled
Task 4: Configuring a SIP trunk between Cisco Unified CM and
TelePresence Conductor
TelePresence Conductor
Follow the
to configure a SIP trunk between Cisco Unified CM and TelePresence Conductor.
Task 5: Adding additional configuration on Cisco Unified CM
On the Cisco Unified CM
1. Go to
Call Routing > Route/Hunt > Route Pattern
and add a route pattern with the following settings
(all other settings can be left as default):
Route Pattern
3XXX
(the conference alias that matches the Multiway URI configured on a VCS-
registered endpoint)
Gateway/Route
List
List
Select the TelePresence Conductor SIP trunk.
2. Go to
Device > Device Settings > SIP Profile
and check that the SIP profile used by the VCS SIP trunk
has Redirect by application ticked.