Cisco Cisco TelePresence Video Communication Server Expressway
Routing configuration
Cisco VCS Deployment Guide: Basic configuration – VCS Control with VCS Expressway
Page 23 of 69
Step 8: Traversal zone including authentication (connection
credentials) configuration
credentials) configuration
The traversal zone configuration defines a connection between the VCS Control and VCS Expressway
platforms.
platforms.
n
A traversal zone connection allows firewall traversal for signaling and media between the two platforms.
n
The VCS Control is configured with a traversal client zone, and the VCS Expressway with a traversal
server zone.
server zone.
To configure the traversal zone:
1. Go to the
Zones
page (
VCS configuration > Zones)
.
2. Click New.
3. Configure the fields as follows (leave all other fields with default values):
VCS Control
VCS Expressway
Name
Enter TraversalZone
Enter TraversalZone
Type
Select Traversal client
Select TraversalServer
Hop count
Enter 15
Enter 15
Username
Enter exampleauth
Enter exampleauth
Password
Enter ex4mpl3.c0m
Not applicable
H.323 Mode
Select On
Select On
H.323 Protocol
Select Assent
Select Assent
H.323 Port
Enter 6001
Enter 6001
H.323 H.460.19 demultiplexing mode
Not applicable
Select Off
SIP Mode
Select On
Select On
SIP Port
Enter 7001
Enter 7001
SIP Transport
Select TLS
Select TLS
SIP TLS verify mode
Select Off
Select Off
SIP Accept proxied registrations
Select Allow
Select Allow
SIP Poison mode
Select Off
Select Off
Authentication policy
Select Do not check credentials Select Do not check credentials
Client settings Retry interval
Enter 120
Not applicable
Location Peer 1 address
Enter 192.0.2.2
Not applicable
4. Click Create zone.